DiSEqC Generator

 To convert the standard switching commands (14 / 18V, 0 / 22KHz) into DiSEqC 1.0 commands.

 To be fitted into receiver downlead cable.

 Enable the access to 4, 8, 12 or 16 SAT IF polarities in combination with DiSEqC switches.

 Last switching state is maintained even after switch off the device.

22KHz Generator

 To generate a continuous 22 kHz tone.

 Input: F connector (male) for direct connection. Output: F connector (female).

DC Blocker

Set = 2 pcs

Multiple Splitter 16 SAT/1 Terrestrial in 32 SAT/2 Terrestrial out

16 SAT-IF splitter

VTS 17217, VTS 13213, VTS 929, VTS 525, VTS 545

 To be used in large distribution networks with multiple supply lines, these splitters reduce the installation expenditures substantially. This means the RF signal of the terrestrial trunk line and the 16 / 12 / 8 / 4 SAT IF trunk line is divided in each case into two trunk lines. Each trunk line has a separate DC - pass, which is connected with the respective output ports.

 The VTS 545 offers 4 x 5 outputs.

SAT Multiswitch for 16 SAT IF signals and terrestrial with 16 subscriber outputs

Compact Multiswitch with active terrestrial 17 in 8 and 16 out

SMS 17807 NF, SMS 171607 NF

For 8 and 16 subscribers.
 Both devices feature 16 active SAT IF inputs and an active terrestrial input. The SMS 17807 NF offers 8 subscriber outputs and the SMS 171607 NF has 16 subscriber outputs. Both devices are supplied with an integrated energy - saving switched - mode power supply and the SPAUN typical standby function.

SAT IF:
 Can be used with Quattro or QUAD LNBs.
 A special amplifier, filter design improves the intermodulation properties of the compact multiswitch considerably.
 The high selective input filter guarantees that interference products of the LNBs can‘t drive the amplifiers into saturation.
 The multiswitch supports standby mode. Both the SAT IF amplifier, as well as the remote power supply of the LNBs are only active if at least one receiver provides a supply voltage to its multiswitch outlet.

Terrestrial:
 Active forward path 85 ~ 862MHz.
 Passive return path 5 ~ 65MHz for the use of interactive signals (Triple Play).

Miscellaneous:
 Ground clamp.
 The device is equipped with an energy - saving switched - mode power supply.

SAT Multiswitch for 16 SAT IF signals and terrestrial with 8 subscriber outputs

Compact Multiswitch with active terrestrial 17 in 8 and 16 out

SMS 17807 NF, SMS 171607 NF

For 8 and 16 subscribers.
 Both devices feature 16 active SAT IF inputs and an active terrestrial input. The SMS 17807 NF offers 8 subscriber outputs and the SMS 171607 NF has 16 subscriber outputs. Both devices are supplied with an integrated energy - saving switched - mode power supply and the SPAUN typical standby function.

SAT IF:
 Can be used with Quattro or QUAD LNBs.
 A special amplifier, filter design improves the intermodulation properties of the compact multiswitch considerably.
 The high selective input filter guarantees that interference products of the LNBs can‘t drive the amplifiers into saturation.
 The multiswitch supports standby mode. Both the SAT IF amplifier, as well as the remote power supply of the LNBs are only active if at least one receiver provides a supply voltage to its multiswitch outlet.

Terrestrial:
 Active forward path 85 ~ 862MHz.
 Passive return path 5 ~ 65MHz for the use of interactive signals (Triple Play).

Miscellaneous:
 Ground clamp.
 The device is equipped with an energy - saving switched - mode power supply.

SAT Cascadable Multiswitch for 16 SAT IF signal and terrestrial with 8 subscriber outputs

Launch Amplififier 17 in 8 out

Useable as stand-alone switch for 8 subscribers; for cascading with SMK 17xx9 F(A); as post amplifier or to terminate a cascadable system.

SAT IF:
 Synchronous level adjuster for each SAT IF system.
 LNB supply voltage selectable for the use of Quattro or QUAD LNBs.

Terrestrial:
 The terrestrial input is passive and return path compatible with the possibility of a 18 V (250 mA) remote power in both directions for an external amplifier.

Miscellaneous:
 Selective standby function: If all subscribers watch TV programms of SAT system A only the appropriate LNB is supplied with power. The internal logic turns off the power supply of all other LNBs as well as for the integrated amplifiers. This process results in significant energy - savings.
 Ground clamp.
 The device is equipped with an energy - saving switched - mode power supply.

Cascadable Multiswitch for 16 SAT IF signals and terrestrial with 16 subscriber outputs

Cascadable Multiswitches 17 in 8, 12 ,16

Premium Class - Amplification in each subscriber outlet (SMK 17169 FA)

SMK 17xx9 F, SMK 17xx9 FA (active)

 For 8, 12 or 16 subscribers either as an active version with amplification in the SAT IF path (SMK 17xx9 FA) or as a completely passive version (SMK 17xx9 F).

Cascadable Multiswitch for 16 SAT IF signals and terrestrial with 16 subscriber outputs

Cascadable Multiswitches 17 in 8, 12 ,16

Premium Class

SMK 17xx9 F, SMK 17xx9 FA (active)

 For 8, 12 or 16 subscribers either as an active version with amplification in the SAT IF path (SMK 17xx9 FA) or as a completely passive version (SMK 17xx9 F).

Cascadable Multiswitch for 16 SAT IF signals and terrestrial with 12 subscriber outputs

Cascadable Multiswitches 17 in 8, 12 ,16

Premium Class - Amplification in each subscriber outlet (SMK 17129 FA)

SMK 17xx9 F, SMK 17xx9 FA (active)

 For 8, 12 or 16 subscribers either as an active version with amplification in the SAT IF path (SMK 17xx9 FA) or as a completely passive version (SMK 17xx9 F).

Cascadable Multiswitch for 16 SAT IF signals and terrestrial with 12 subscriber outputs

Cascadable Multiswitches 17 in 8, 12 ,16

Premium Class

SMK 17xx9 F, SMK 17xx9 FA (active)

 For 8, 12 or 16 subscribers either as an active version with amplification in the SAT IF path (SMK 17xx9 FA) or as a completely passive version (SMK 17xx9 F).

Cascadable Multiswitch for 16 SAT IF signals and terrestrial with 8 subscriber outputs

Cascadable Multiswitches 17 in 8, 12 ,16

Premium Class - Amplification in each subscriber outlet (SMK 17089 FA)

SMK 17xx9 F, SMK 17xx9 FA (active)

 For 8, 12 or 16 subscribers either as an active version with amplification in the SAT IF path (SMK 17xx9 FA) or as a completely passive version (SMK 17xx9 F).